Fitting Help

Watch the two-minute setup video or follow the four simple steps below to fit your Soap Shower. No tools are required.

Fit Your Soap Shower in Two Minutes

No tools required · Fits in minutes · Hand-tighten only

Multicolumn

  • Attach your shower hose to Soap Shower

    Unscrew your existing shower hose from the shower outlet.

    Then screw the shower hose onto the bottom of Soap Shower.

    Hand-tighten only.

  • Attach Soap Shower to the shower outlet

    Screw the top of Soap Shower onto the shower outlet where the hose was originally connected.

    Make sure the black rubber washer is inside the top connection.

    Hand-tighten only.

  • Fit the supplied shower head

    Unscrew your existing shower head and fit the supplied aerated shower head.

  • Fill the refill container

    Lift the lever fully and pull out the refill container.

    Add your preferred shower gel, then replace the container and lower the lever.
Button label

Check the top connection

After fitting, Soap Shower should swivel from side to side with some resistance.

If it swings freely or leaks from the top connection, hand-tighten it a little further until snug.

Do not use tools or overtighten.

Need help fitting your Soap Shower?

Send us a clear photograph showing the shower outlet, Soap Shower and hose connection. We will help identify what needs adjusting.

Get fitting helpGo to troubleshooting